OsmosisIsthe passage of waterfrom a region of high water concentrationthrough aSemi-Permeable membraneTo a region of low water concentration.
ACrystalOr Crystalline solid Is a solid material whoseatoms, molecules, or ions are arranged in an orderly, repeating geometric pattern.
This superabsorbent polymer compound has very long carbon chains bonded with sodium atoms in the centre of the molecule inrepeating units of -CH2-CH(COONa). When sodium polyacrylate is exposed to water, the higher concentration of water outside the polymerdraws the water into the centre of the molecule via osmosis. Sodium polyacrylate will continue to absorb water until there is an equal concentration of water inside and outside the polymer. This formsa polymeric gel many times larger in size than the original powdered compound.
Superabsorbent polymers are being considered for use to solidify liquid waste because the polymer can absorbmany times it weight in water with less than 1% increase in waste volume. Avoiding an increase in the waste volume also meansfewer loads of waste being shipped to landfills.In this project, figure out which polymer would be most absorbent.
- Sodium polycrylate is non-toxic! However, if it gets in your eyes, theywill become dry and irritated. Inhaling the powder will also be irritating to nasal membranes. Dispose of excess powder and/or gelled material in the trash. Do not put it down the sink!
- Do not ingest the hydrogel crystals or drink the water used withthese crystals. These crystals are extremely slippery, so be careful aroundspillage. Never flush or pour these crystals down the drain, as crystal swelling couldclog drainpipes.
- Hydrogel crystals
- Superabsorbent baby diapers
- Wax paper
- 8 oz plastic glasses
- Measuring cup
- Plastic spoons
- Distilled water
- Colander or funnel
- Digital camera
- Box of table salt
- What is a polymer?
- What is a superabsorbent polymer?
- How are hydrogel crystals different from sodium polyacrylate? How are they the similar?
- How does the absorbency of the hydrogel compare with sodium polyacrylate?
- In addition to its use in disposable diapers, what are some other uses for sodium polyacrylate?
- Based on the results of the investigation which superabsorbent polymer would be best to use to solidify liquid waste?
- Place a new super-absorbent diaper on a piece of wax paper, cut the diaper in half and pull out some of the fibers.
- Shake the fibers and pull them apart, allowing the powdery granules to fall onto the paper.
- Discard the fibers. The white granules that remain are sodium polyacrylate.
- Repeat steps 1-4 with another diaperuntil there is 1 tablespoon of the powder.
- On another sheet of wax paper, place 10 hydrogel crystals in a pile.
- Next to them pour an equal amount of sodium polyacrylate granules removed from the diapers.
- Carefully pour the two polymers into separate 8 oz plastic glasses or cups and label them.
- Using a measuring cup add 50 ml (or 6 oz) of distilled water to each glass.Stir the water in both glasses with plastic spoons.
- The sodium polyacrylate will start absorbing water and swelling, and the hydrogel crystals will begin to grow immediately.
- Observe and record what happens to the two substances after 30 minutes, 1 hour, and 1 ½ hours.
- Allow the hydrogel crystals to grow to thepoint where they cannot be seen clearly inside the glass and allow the sodium polyacrylate to gel until it reaches its maximum expansion.
- Measure the unabsorbed water in each glass by poring the liquids into a measuring cup, using a strainer, colander, or funnel to catch the crystals and gel.
- Record how much water is left after crystal and gel absorption by subtracting the amount left from 50 ml (6 ounces) and record in a table similar to the one shown below.
Name of Super-absorbent
Amount after absorbent addition
- Using the data in the table plot a line or bar graph of Amount of liquidAbsorbed by the two absorbents along the Y-axis verses their names along the X-axis.
As an extension to this project, take the unusedsodium polyacrylate granulesremoved from the diaper and place them ina dish.Add water,and once again the polymer willstart absorbing the water and swelling. Keep adding water until the granulesstop swelling.
Next, add table salt to the gel. This addition will cause it to turn back to a liquid because salt has a higher concentration of sodium ions on the outside of the polyacrylate particles. The water is attracted to the salt, which causesthe water to leave the polymer particles. The particlesthencollapse and become a liquid again. This process is called osmosis.
Follow the same procedure using the hydrogel crystals to see if the same thing happens whensalt is added to these crystals.